Trane XR80 Blinking Red Light Furnace Troubleshooting
Posted on by
Trane Flash Codes. Trane Xr80 Flashing Red Light Codes Red Light Flashing 4 Times [Tripped High-Limit Switch] It is a common scenario of the Trane furnace that the red light blinks four times and blows cold air only (failure to ignite, no spark, low/ no gas pressure, etc.) 3 Flashes: Pressure switch problem detected
Trane xv90 control board blinking, and red flash together every second from www.justanswer.com
Below is a table that outlines the diagnostic flash code meanings for the Trane XR80 furnace: Flash Pattern Meaning; Flashing Slow: Normal - no call for heat: Flashing Fast: Normal - call for heat: Continuous On: Replace control: Continuous Off: Check for power: 2 Flashes: System lockout (no flame) or reversed polarity: Fail Code: Possible Cause or Next Step: J6-6: J6-7: Pulsing: Heat: Gas heat (See ignition module for further fault codes): If any failure occurs such as loss of flame, limit switch trip, flame rollout etc
Trane xv90 control board blinking, and red flash together every second
Fail Code: Possible Cause or Next Step: J6-6: J6-7: Pulsing: Heat: Gas heat (See ignition module for further fault codes): If any failure occurs such as loss of flame, limit switch trip, flame rollout etc To reset your furnace, locate the power switch or thermostat and turn it off for a few minutes. Flashing Red LED - The sensor is not detecting proper temperature, indicating a possible faulty sensor or a wiring issue.
Trane Furnace Error Codes Expert Answers to Common Issues. 4 highest priority Faults display flash codes sequentially Supply air temperature sensor failure and unit is CV with modulating heat or modulating reheat
Why am I getting an 8 flash code on my economizer? Trane Commercial. 2 second pause between faults and 4 second pause between sequences Flashing 4 times on the red light mainly notifies that the high limit switch has been tripped.